Whiplash Gasser - AXON settings

$ 0.00

incl. 19% VAT , plus Select Tax Zone / Country of Delivery

For the Whiplash-G II gas powered helicopter it is very important to use a governor.

The following settings are for AXON and are only a basic setup. This basic setup does not replace any information of the AXON manual.

These settings can differ from your optimum setting because of different blades, engine and so on.

For maximum power we recommend a head speed of about 1950 rpm.

Always follow the AXON manual and its safety recommendations.

SETUP:

Basic Setup:

Governor Settings:

Waiting Time: 4
Increased Idle Position: -55 (only an example value, set according to your model and follow instructions of AXON manual)
Spool-Up Time: 12
Max. Throttle Position: +66 (only an example value, set according to your model and follow instruction of AXON manual)
Control Gain: 30 (depends on blades, engine, for example. This is an initial value.)

Tail Gyro Settings:

Gyro Gain: +54 (depends on blades for example. This is an initial value.)
P-Gain: 16
D-Gain: 3
Agility: 9
Lock-In Delay: 9
Revo Mix: 0
Servo Travel Tail Left: 100 (depends on your mechanical settings. Try to reach 90% to 100% for each direction left and right)
Servo Travel Tail Right: 100
Servo-Type Tail: Digital1 - 166 HZ (a Servo with 1520µs center pulse-width is recommended)